Cleaning The Machine And The Motor; Nuts And Bolts; Occasional Maintenance; Cutting Means Maintenance - Mountfield BC 500 Li 48 Manual De Instrucciones

To optimise battery power reserve
it is always recommended to:
• cut the grass when dry;
• set a cutting speed suitable for
the condition of the grass;
• use the most appropriate cutting means and
technique for the work to be performed.
If the need arises to use the machine for
sessions which exceed the capability of
a standard battery, it is possible to:
• purchase a second standard battery
to immediately replace the discharged
battery, without compromising
the continuity of operations;
• purchase a battery with an extended
power reserve compared to the
standard version (par. 15.1).
7.2.2 Battery removal and recharging
1. Press the locking button located in
the battery housing (Fig. 16.A) and
remove the battery (Fig. 16.B);
2. fit the battery (Fig. 17.A) in the battery
charger housing (Fig. 17.B);
3. connect the battery charger (Fig. 17.B)
to a power socket with the
indicated on the rating plate;
4. fully charge the battery according
to the instructions in the battery/
battery charger booklet.
NOTE The battery is equipped with a guard
that inhibits recharging if the environmental
temperature is not between 0 and +45 °C.
NOTE The battery can be recharged at any
time, even partially, with no risk of damaging it.
7.2.3 Refitting the battery on the machine
When recharging is completed:
1. Remove the battery (Fig. 18.A) from the
housing in the battery charger (do not keep
recharging when recharging is completed);
2. disconnect the battery charger (Fig.
18.B) from the electrical mains;
3. fit the battery (Fig. 19.A) in its housing
pressing down until you
into position and check the electrical contact.
voltage
hear it clicks firmly
7.3 CLEANING THE MACHINE
AND THE MOTOR
• Always clean the machine after use with a
damp cloth dipped in neutral detergent.
• Remove all traces of humidity using
a soft damp cloth. Humidity can
generate risks of electric shocks.
• Do not use aggressive detergents or solvents
to clean the plastic parts or hand grips.
• To reduce fire hazards, keep the lawnmower
and, in particular, the motor free of
grass, leaves, or excessive grease.
• To avoid overheating and damage to the
motor or the battery, always keep the cooling
air vents (Fig. 20) clean and free of debris.
• Do not spray water onto the motor
and electrical components and
prevent them from getting wet.
7.4

NUTS AND BOLTS

• Keep all nuts, bolts and screws tight to be sure
the equipment is in safe working condition.
• Check regularly that the
handles are fixed firmly.

8. OCCASIONAL MAINTENANCE

8.1 CUTTING MEANS MAINTENANCE

When servicing the cutting means, bear in mind
that the cutting means can still move even if the
battery has been removed from its housing.
Cutting means displaying the code
indicated on the Technical Data table
should be used on this machine.
Given product evolution, the cutting means
mentioned in the "Technical Data" table may
be replaced in time with others having similar
interchangeable and operating safety features.
Do not touch the cutting means until
the battery has been removed and the
cutting means is completely stationary.
Warning! Risk of injuries due
to dangerous moving parts!
EN - 15