General Information; After Use; Routine Maintenance - Mountfield BC 500 Li 48 Manual De Instrucciones

6.6 STOP
To stop the machine:
1. release the throttle control lever (Fig. 7.A);
2. deactivate the safety button (Fig. 7.C),
3. wait until the cutting means stops.
When you have stopped the
machine, it will take a few seconds
for the cutting means to stop.
IMPORTANT Always stop the machine
when moving between work areas.
Do not keep your finger on the safety
button when moving the machine to avoid
accidentally enabling the machine.

6.7 AFTER USE

• Remove the battery from its housing
and recharge it (par
• When the cutting means has halted,
fit the blade guard (Fig. 1.J).
• Allow the motor to cool before
storing in an enclosed space.
• Clean (par. 7.3).
• Make sure there are no loose or damaged
components. If necessary, replace
the damaged components and tighten
any screws and loose bolts or contact
the authorised service centre.
IMPORTANT Always remove the battery
(par 7.2.2) and fit the glade guard whenever
you leave the machine unused or unattended.

7. ROUTINE MAINTENANCE

7.1

GENERAL INFORMATION

IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these indications to avoid
serious risks or dangers.
Prior to carrying out any
maintenance operation, you need to:
• stop the machine;
• remove the battery from its housing
and recharge it (par 7.2.2);
7.2.2).
• when the cutting means is stationary,
apply the blade protection device, (except
when working directly on the blade);
• allow the motor to cool before
storing in an enclosed space;
• use suitable clothing, protective
gloves and goggles;
• read the relevant instructions.
– The frequency and types of maintenance
are summarised in the "Maintenance
Table" (chapter 13). The table will
you maintain your machine's safety
and performance. It summarises the
main interventions to be made and the
frequency applicable to each of them.
Carry out the relevant task as soon
as it is scheduled to be performed.
– The use of non-genuine spare parts and
attachments could adversely affect machine
operation and safety. The manufacturer
declines all liability for any damage or
injuries caused by these products.
– Genuine spare parts are supplied
by Authorised Assistance
Centres and Dealers.
IMPORTANT Any maintenance and
adjustment operations not described in
this manual must be carried out by your
dealer or Authorised Service Centre.
7.2 BATTERY
7.2.1 Battery power reserve
Battery power reserve (and therefore the
cuttable vegetation area before recharging
is required) mainly depends on:
a. environmental factors, that cause
higher energy requirements:
– cutting, high, wet vegetation;
b. operator behaviour that should be avoided:
– switching the machine on and off
frequently whilst working;
– using a cutting means or cutting
technique that is unsuitable for the
work to be performed (par. 6.4);
– cutting speed unsuitable for the
condition of the grass to be cut.
EN - 14
help