Handling And Transportation; Assistance And Repairs; Warranty Coverage; Maintenance Table - Mountfield BC 500 Li 48 Manual De Instrucciones

10. HANDLING AND TRANSPORTATION

Whenever the machine is to be
handled or transported you must:
– stop the machine (par. 6.6);
– remove the battery from its housing
and recharge it (par. 7.2.2);
– when the cutting means has
halted, fit the blade guard;
– wear heavy work gloves;
– only hold the machine using the
hand grips and position the cutting
means in the opposite direction to
that used during operations.
When transporting the machine
on a vehicle, always:
– fasten the machine securely
with cables or chains;
– position it so that it can not cause
a hazard for anybody.

11. ASSISTANCE AND REPAIRS

This manual provides all the necessary
information to run the machine and for correct
basic maintenance operations which can
be performed by the user. Any regulations
and maintenance operations not described
herein must be carried out by your Dealer
or Authorised Service Centre, which have
the necessary knowledge and equipment to
ensure that the work is carried out correctly,
maintaining the correct degree of safety and the
original operating conditions of the machine.
Any operations performed in unauthorised
centres or by unqualified persons will totally
invalidate the warranty and all obligations
and responsibilities of the manufacturer.

13. MAINTENANCE TABLE

MACHINE
Check all fasteners
Safety checks/check controls
Check the cutting means guard.
Checking the cutting means
Check the battery charge status
Recharge the battery
Cleaning the machine and the motor
Checking for any damage to the machine. If
necessary, contact the authorised service centre.
* Refer to the battery/battery charger manual.
Intervention
• Only Authorised Service Centres can carry
out guaranteed repairs and maintenance.
• The Authorised Service Centres only
use genuine spare parts. Genuine
spare parts and attachments have been
designed specifically for machines.
• Non-genuine spare parts and accessories are
not approved. Use of non-genuine spare parts
and accessories cause the warranty to expire.
• It is advisable to send your machine
once a year to an Authorised Service
Centre for servicing, assistance
and safety device inspection.

12. WARRANTY COVERAGE

The warranty covers all material and
manufacturing defects. The user must
follow all the instructions provided in
the accompanying documentation.
The warranty does not cover damage caused by:
• Failure to become familiar with the
documentation accompanying the machine.
• Carelessness.
• Incorrect or prohibited use or assembly.
• Use of non-genuine spare parts.
• Use of attachments not supplied or
not approved by the manufacturer.
The warranty does not cover:
• Normal wear and tear of consumables,
such as cutting means, safety bolts.
• Normal wear and tear.
The purchaser is protected by his or her own
national legislation. The purchaser's rights under
the national laws or his or her own country are
not in any way restricted by this warranty.
Frequency
Before each use
Before each use
Before each use
Before each use
Before each use
After each use
After each use
After each use
EN - 17
Notes
par. 7.4
par. 6.2
par. 6.2.1
par. 6.2.1
*
par. 7.2.2
*
par. 7.3
-