Removing And Attaching The Back Wheels; Fixing The Swivel Front Wheels; Adjustment Of The Parking Brake; Adjustment Of The Reclined / Upright Position - Kiddy Urban Star 1 Manual De Instrucciones

EN

3.7 Removing and attaching the back wheels

To remove the back wheels at each side pull the button at the back wheel holder
(fig . 13, no . 1) and pull out the wheel set simultaneously (fig . 13, no . 2) .
To attach the back wheels push the horizontal axle in the hole of the respective
back wheel holder at each side of the frame until it locks .
Check by hand pull tests whether both back wheels are locked securely to the
frame .

3.8 Fixing the swivel front wheels

Bring the front wheels in "straight forward" direction . Afterwards push the but-
tons downwards (fig . 14, no . 1) at each side .
If you want to use the swivel wheels push both buttons upwards (fig . 14, no . 2)
at each side .

3.9 Adjustment of the parking brake

To set the parking brake push the pedal at right side downwards (fig . 15, STOP) .
Don't let go of the buggy until you are sure that the parking brake is fully
engaged .
To loosen the parking brake push the pedal at left side downwards (fig . 16, GO) .

3.10 Adjustment of the reclined / upright position

To adjust the reclining position push both buttons of the adjuster inwards (fig . 17,
no . 1) and adjust the backrest upwards by pulling at the belt (fig . 17, no . 2, a) or by
pulling at the backrest downwards in lie-flat position (fig . 18, no . 2, b) .
For new borns is indended the lowest lie-flat position (fig . 18, no . 2, b) .
21