Make sure that the clips lay flat (fig . 23, no . 3) on the rear of the backrest and the
seat, that the belts are not twisted and that the belt system is complete (fig . 34) .
6.2 Removing and mounting the cover
Remove the sun canopy like described in section 3 . 4 . Remove the 5-point belt
system like described in section 6 . 1 .
To remove the cover open at first the push button on each side below the hand-
le bar (fig . 29, no . 1 ) and the two loops (fig . 29, no . 2), then open the two push
buttons on each side within the seat . Now open under the seat the two loops at
each side (fig . 30, no . 1–2) and open the belt (fig . 30, no . 3) . Pull the cover from
the frame (fig . 33, no . 1) .
To mount the cover follow the steps for removing in reverse order!
Don´t forget to mount the 5-point belt system described in section 6 . 1 .
7. Care and maintenance
7.1 Care and maintenance of the chassis
Periodically check the chassis for loose screws, rivets or worn out or defective
parts . Check the fabric cover and belts for open seams or other defects .
Don't use the buggy when you noticed a defect . Defective parts have to be chan-
ged or repaired before using the buggy again . If a wheel is squeaking spray some
liquid silicone lubricant on the axles . Wipe off unnecessary lubricant .
The chassis can be cleaned with a mild cleanser or with a damp cloth . Never use
caustic cleansing agents (e . g . solvents, strong detergents) .
EN
25
25