Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Description
1
Foil protection cap
2
Shaver foil
3
Cutter block
4
Rotating styler
4a Wide shaper (1.1 in / 28 mm)
4b Narrow shaper (0.55 in / 14 mm)
5
Charging light
6
On/off switch
7
Trimming attachment
8
Beard length selector
9
Special cord set
10 Short beard attachment
Charging
The best environmental temperature for charging is between
60 °F to 95 °F / 15 °C to 35 °C. Do not expose the shaver to
temperatures higher than 122 °F / 50 °C for extended
periods of time.
•
Using the special cord set, connect the shaver to an
electrical outlet with the motor switched off.
•
When charging for the first time, leave the shaver to
charge continuously for 4 hours. The green charging light
(5) shows that the shaver is being charged. When the
battery is fully charged, the charging light intermittently
blinks on and off. This indicates that the battery maintains
its full capacity.
•
A full charge provides 30 minutes of cordless shaving time
depending on your beard growth.
•
Once the shaver is completely charged, discharge the
shaver through normal use. Then recharge to full capacity.
Subsequent charges will take about 1 hour.
•
Maximum battery capacity will only be reached after
several charging/discharging cycles.
•
If the rechargeable batteries are discharged, you may also
shave by connecting the shaver to an electrical outlet via
the special cord set.
Shaving
First, remove the trimming attachment (7): Using your
thumbs, press against the side clips of the trimming
attachment so that they swing off in the direction of the
arrows (a). Activate the on/off switch (6). The floating foil
frame automatically adapts to your skin surface for a close,
smooth shave.
8
Publicidad
Tabla de contenido
