Chaparral Monterey Instrucciones De Montaje página 7

V
x 8
Profile edge
FIG. 6
Profile edge
6. Place the Upper Top (E) on a protective surface with bottom side and the profile on the
edge up. Position the upper assembly (A, C, D) on top of the Upper Top (E) as shown in
Figure 6. Align the upper assembly so that it is centered with equal distance on either side
and flush to the back of the Upper Top (E). Make sure the profiled edges of the upper and
lower tops are going the same direction. Use Screw (V) through the cleats (attached to
the left and right upper sides [A & D]) and the Sleeper (B) to secure pieces together. See
Figure 6. Set assembly aside.
T
x 2
V
x 2
Flush to Bottom edge
7. Attach two Sleepers (B) to Left Lower Side Assembly (F) gluing Wood Dowels (S) and
securing with Screws (T) as shown in Figure 7. Make sure the edge of the Sleepers (B) stay
straight and flush to the edge of the Left Lower Side Assembly (F).
Position the Base (G) so that the arch is down and the radius edge is up and out from the unit.
The bottom edge of the Base (G) needs to be flush with the bottom edge of the Left Lower
Side Assembly (F). Use two Screws (V) through the cleat to secure the Base (G) in place.
V
V
V
Stain Test Area
V
V
(not cleat)
FIG. 7
V
T
BOTTOM
S
Flush with back edge
T
Flush with top
edge
S
TOP
BACK
549W – Page 7
Flush