Model 206 And 246 Soil Pipe Cutters; Description; Operating Instructions; Cutter Set-Up - RIDGID 206 Manual Del Usuario

Soil Pipe Cutters
Models 206 and 246 Soil Pipe
Cutters

Description

The Models 206 and 246 are ratchet-type soil pipe cut-
ters. The ratcheting action parallel to the pipe makes the
206 and 246 the ideal tools for cutting pipe in trenches
of limited width. The Model 206 is a lightweight tool
designed for cutting no hub pipe, whereas the 246 is a
heavier duty tool able to cut hub and service weight cast
iron pipe. The models 206 and 246 are the only soil pipe
cutters that feature an integral ratchet handle.

Operating Instructions

WARNING
Make sure you have read and understood the
safety information in this brochure before at-
tempting to operate this tool.
Ratchet Knob
Inner Side
Arm
Chain Pin
Figure 5
Chain Pin
Figure 6

Cutter Set-Up

1. Lift and turn ratchet knob to neutral position (pin
2. Turn adjusting knob until jaws are fully open. (Figures
3. When working conditions permit, place cutter on pipe

Adjusting the Chain

1. After cutter is properly set, wrap chain around the pipe
2. Set proper chain pin into hooks. Make sure you hook
3. Turn adjusting knob so that arrow points to word
Adjusting
Knob
Outer Side

Cutting the Pipe

Arm
1. Ratchet handle in the direction indicated by the arrow
Hook
If ratcheting action stops before the pipe is cut,
the tool has been jammed. DO NOT force the han-
dle or adjusting knob, simply lift, turn and hold
ratchet knob so that the arrow points to word
OPEN on ratchet housing. Push in ratchet knob to
ensure engagement of pawl. Use ratchet action in
the direction indicated by the arrow to release
the chain. Reset cutter by hooking the next pin in
line to assure ample travel for cutting action.
Ridge Tool Company
Ratchet Pin
Inner Side Arm
should not be in groove). (Figure 5)
5 and 6)
with adjusting knob on the right, while straddling the
long end of the pipe.
snugly.
the pin that leaves the least slack in the chain.
CUT on the ratchet housing, (Figure 5). Chain must be
properly set to assure ample travel for cutting action.
on ratchet knob until the pipe is cut. Avoid raising
ratchet handle too close to the vertical position as this
makes the ratcheting action more difficult.
IMPORTANT
Adjusting Knob
Outer Side Arm
5