Wireless Thermo-Hygro Sensor; Installation And Setup; Install Wireless Thermo-Hygro Sensor - Bresser Tuya Smart Manual De Instrucciones

WIRELESS THERMO-HYGRO SENSOR

1 . LED indicator
2 . Wall mounting holder
3 . Channel slide switch
4 . [ RESET ] key
5 . Battery compartment

INSTALLATION AND SETUP

INSTALL WIRELESS THERMO-HYGRO SENSOR

1 . Remove the battery door of the sensor .
2 . Use the channel slide switch to set the channel number for the
sensor (e .g . Channel 1)
3 . Insert 2 x AA size batteries into the battery compartment according
to the polarity marked on the battery compartment, and close the
battery door .
4 . The sensor is in synchronization mode, and can be registered to the
console within the next few minutes . The transmission status LED
will begin to flash every 1 minute.
NOTE:
- If you need to re-assign the sensor channel, slide the channel slide switch to the new channel position
and press [ RESET ] key on the sensor for the new channel number to be effective.
- Avoid placing the sensors in direct sunlight, rain or snow .
- To avoid the sensor/s and console pairing failure during new console setup, please power up the
sensor(s) first, and then press [ SENSOR/WiFi ] key on the main unit .
PLACING THE WIRELESS THERMO-HYGRO SENSOR
Place a screw on the wall that you wish to hang the sensor on .
Hang the sensor onto the screw by the wall mounting holder . You
can also place the sensor on a table by itself .
1
25
2
3
4
5
EN