Best K210A Instrucciones De Instalación página 8

8. INSTALL THE ADAPTER (INTERIOR BLOWER)
Using two (2) standard 1/2" screws, secure the adapter to the top (or back) of the hood. Seal the adapter to the hood
using metal foil duct tape.
NOTE: For vertical exhaust, please make sure that the damper pivot is located towards the front of the hood.
HD0005 HD0006
9. INSTALL THE HOOD (INTERIOR & EXTERIOR BLOWER)
INTERIOR BLOWER: Run power cable to installation location. Place the hood to its location. Mark the position of the
screws (smaller part of the key holes) with a pen. Remove the hood and install the (8) 1/2" double thread screws
leaving a 1/8" gap (4 screws for 30" hood). Remove wiring cover, place the wire clamp, insert the cable in the hood and
tighten the wire clamp to secure the cable. Place the hood under the cabinet and slide it in position. Make sure the
adapter/damper assembly enters the ducting. Secure the hood by tightening the screws completely.
HD0043
EXTERIOR BLOWER: Run power cable to installation location. Place the hood to its location. Mark the position of the
screws (smaller part of the key holes) with a pen. Remove the hood and install the (8) 1/2" double thread screws
leaving a 1/8" gap (4 screws for 30" hood). Remove wiring cover on top of the hood and connect wiring (see instructions
included with exterior blower). Place the hood under the cabinet and slide it in position. Secure the hood by tightening
the screws completely.
- 8 -