Light Bulbs - Best K210A Instrucciones De Instalación

12. LIGHT BULBS

This range hood must use shielded halogen lamps (120 V, 50 W, MR16 or PAR16 with GU10 base), included.
In order to prevent the risk of personal injury, do not install a
lamp identified for use only in enclosed fixtures.
1. Install the lamps by placing the bulb leads into their grooves in the socket.
2. Gently push upwards and turn clockwise until secure.
In order to prevent the risk of personal injury, the halogen
lamps must be cooled down before removing them.
To remove lamps, gently push upwards and turn counterclockwise to disengage bulb leads from their grooves.
NOTE: If need be, use a rubber dishwashing glove to add grip when removing the bulb.
13. INSTALL BAFFLE FILTERS
Remove protective plastic film covering filters before installing them.
NOTES: 1. Assemble the metal handles to the filters, using no. 8-32 x 1/4" screws provided, before installing them in
the hood.
2. A vertical arrow with the word AIR can be found on the filter
border. Make sure to install the filters with this arrow pointing
toward the inside of the hood.
3. If needed to ease baffle filters installation, remove and discard the clips from
the hood grease channel by removing the screws.
It is recommended to install side filters first and finish with center one(s).
1. Insert front end of the filter inside front of the hood.
2. Raise lower end toward the inside of hood and insert into channel.
3. Slide filter under the inner retaining piece.
WARNING
!
WARNING
!
CAUTION
HO0090
HD0095
HD0104
- 11 -
1 2
HO0001
1
3
2