Programming The Rf Remote Control (Optional); Operating A Device With Your Programmed Remote Control (Rf) - Samsung SIR-TS360 Manual Del Propietário

8
8
CHAPTER 8
Programming the remote control

Programming the RF remote control (optional)

This chapter explains how to program your RF remote control so that you can use it to
operate your TV, VCR. Chapter sections include:
Programming the RF remote control
Operating a device with your programmed remote control
Programming the RF remote control
Your DIRECTV ® HD Receiver's remote control can be programmed to operate your TV, VCR.
You use the code lists provided in your "RF Remote Control" manual to enter the code for your brand
of TV, VCR.
Method
To use the manual method to program your DIRECTV
these steps:
Turn on the device you want to control.
1
Aim the DIRECTV HD Receiver's remote control at the device.
®
2
After pressing a device button to operate the remote control in a desired device mode, press
3
the SET button once again with a sharp thing, like pen. The device button lights up.
The SET button
108
® HD Receiver's remote control, follow
The device buttons
8
8
CHAPTER 8
Programming the remote control
Enter the three-digit code for your device (see the code lists on the "Remote Control" manual)
4
If the entered code is correct, the device will turn off.
Press the device button again. The button should blink twice and then turn off.
5
Repeat the procedure for other devices you wish to operate with your DIRECTV
6
RF remote control.

Operating a device with your programmed remote control (RF)

To operate a device using your programmed RF remote control, you must first press the
corresponding device button (TV, VCR or DIRECTV).
Then use the RF remote control to operate that device.
The RF remote control will continue to operate that device until you press another device
button. Each time you want to button to a different device with your RF remote control,
you start by pressing a device button.
NOTE
When working with the TV and VCR device remote control, the IR signal will be transmitted.
Therefore, you need to at the device to work with.
® HD Receiver's
109