Noise/Vibration Information; Declaration Of Conformity; Mounting And Operation - Bosch AQT 35-12 Manual Original

OBJ_DOKU-35451-007.fm Page 12 Thursday, July 17, 2014 11:40 AM
12 | English

Noise/Vibration Information

Sound emission values determined according to EN 60335-2-79.
Typically the A-weighted noise levels of the product are:
Sound pressure level
Sound power level
Uncertainty K
Wear hearing protection!
Vibration total values (triax vector sum) determined according to EN 60335:
Vibration emission value a
h
Uncertainty K

Declaration of Conformity

We declare under our sole responsibility that the product described under "Tech-
nical data" is in conformity with all relevant provisions of the directives
2011/65/EU, 2014/30/EU, 2006/42/EC, 2000/14/EC including their amend-
ments and complies with the following standards: EN 60335-1, EN 60335-2-79.
2000/14/EC: Guaranteed sound power level:
Conformity assessment procedure according to Annex V.
Equipment category: 27
Technical file (2006/42/EC, 2000/14/EC) at:
Bosch Lawn and Garden Ltd., PT-LG/ENS23,
Stowmarket, Suffolk IP14 1EY, England
Henk Becker Helmut Heinzelmann
Executive Vice President Head of Product Certification
Engineering PT/ETM9
Robert Bosch GmbH, Power Tools Division
70764 Leinfelden-Echterdingen, GERMANY
23.06.2014

Mounting and Operation

Action
Delivery Scope
Fold down handle operation
Connecting high pressure gun to lance 3
Connecting high pressure water supply
hose/nozzle
Attaching Nozzles
Water connection
Switching On and Off
Adjust water jet
Connect detergent bottle
Clean the water filter
Clean nozzle
Gun storage
Gun/lance/nozzle is stored in action
F 016 L70 995 | (17.7.14)
Action
Hose into the hose holder
Storage
Selecting Accessories
Starting
For Your Safety
The operating voltage is 230 V AC, 50 Hz (for non-EU coun-
tries 220 V, 240 V as applicable). Only use approved exten-
sion cables. Contact your Bosch Service Centre for details.
If you want to use an extension cable when operating your
Figure Page
high pressure washer, only the following cable dimensions
1 210–211
should be used:
2 212
- 1.5 mm
- 2.5 mm
213
Note: If an extension cable is used it must be earthed and con-
nected through the plug to the earth cable of your supply net-
4 213
work in accordance with prescribed safety regulations.
5 214–216
If in doubt contact a qualified electrician or the nearest Bosch
6 216
Service Centre.
7 217
8 217
9 218
10 218
Cable connections should be kept dry and off the ground.
11 219
For increased electrical safety to use a Residual Current De-
12 219
vice (RCD) with a tripping current of not more than 30 mA. Al-
13 220
ways check your RCD every time you use it.
3 600 ... HA7 1.. HA7 2..
dB(A) 83
dB(A) 93
dB 2
2
m/s =7
2
m/s =2
3 600 ... HA7 1.. HA7 2..
dB(A) 95
Figure Page
14
15
16
Warning! Switch off, remove plug from mains
before adjusting, cleaning or if cable is cut,
damaged or entangled.
2
– max length 20 m
2
– max length 50 m
WARNING! Inadequate extension cables can
be dangerous. Extension cable, plug and sock-
et must be of watertight construction and in-
tended for outdoor use.
HA7 5..
78 83
90 94
1 2
=2 =4.7
=2 =1.5
HA7 5..
91 96
220
220
221
Bosch Power Tools