Noise/Vibration Information; Declaration Of Conformity; Mounting And Operation - Bosch AQT 42-13 Manual Original

All manuals and user guides at all-guides.com
OBJ_DOKU-40725-003.fm Page 15 Wednesday, February 18, 2015 9:24 AM

Noise/Vibration Information

Sound emission values determined according to EN 60335-2-79.
Typically the A-weighted noise levels of the product are:
Sound pressure level
Sound power level
Uncertainty K
Wear hearing protection!
Vibration total values a (triax vector sum) and uncertainty K determined according to
h
EN 60335-2-79:
Vibration emission value a
h
Uncertainty K

Declaration of Conformity

We declare under our sole responsibility that the product described under "Technical data"
is in conformity with all relevant provisions of the directives 2011/65/EU, until 19 April
2016: 2004/108/EC, from 20 April 2016 on: 2014/30/EU, 2006/42/EC, 2000/14/EC in-
cluding their amendments and complies with the following standards:
EN 60335-1, EN 60335-2-79.
2000/14/EC: Guaranteed sound power level:
Conformity assessment procedure according to Annex V.
Equipment category: 27
Technical file (2006/42/EC, 2000/14/EC) at:
Bosch Lawn and Garden Ltd., PT-HG/ENS-PA2,
Stowmarket, Suffolk IP14 1EY, England
Henk Becker Helmut Heinzelmann
Executive Vice President Head of Product Certification
Engineering PT/ETM9
Robert Bosch GmbH, Power Tools Division
70764 Leinfelden-Echterdingen, GERMANY
17.02.2015

Mounting and Operation

Action
Delivery Scope
Adjusting the Handle
Connecting high pressure gun to lance 3
Connecting high pressure water supply
hose/nozzle
Attaching Nozzle
Connecting to the water supply
Switching On and Off
Clean the water filter
Clean nozzle
Gun storage
Gun/lance/nozzle is stored in action
Bosch Power Tools
Action
Hose into the hose holder
Storage
Selecting Accessories
Starting
For Your Safety
Warning! Switch off, remove plug from mains
before adjusting, cleaning or if cable is cut,
damaged or entangled.
The operating voltage is 230 V AC, 50 Hz (for non-EU coun-
tries 220 V, 240 V as applicable). Only use approved exten-
sion cables. Contact your Bosch Service Centre for details.
If you want to use an extension cable when operating your
Figure Page
high pressure washer, only the following cable dimensions
1 259
should be used:
2
2 260 – 1.5 mm – max length 20 m
2
– 2.5 mm – max length 50 m
261
Note: If an extension cable is used it must be earthed and con-
nected through the plug to the earth cable of your supply net-
4 262
work in accordance with prescribed safety regulations.
5 263-264
If in doubt contact a qualified electrician or the nearest Bosch
6 264
Service Centre.
7 265
WARNING! Inadequate extension cables can
be dangerous. Extension cable, plug and sock-
8 265
et must be of watertight construction and in-
9 265
tended for outdoor use.
10 266
Cable connections should be kept dry and off the ground.
11 266
English | 15
3 600 ... HA7 3.. HA7 4..
dB(A) 81 81
dB(A) 94 94
dB 2 2
2
m/s 2.0 2.0
2
m/s 1.5 1.5
3 600 ... HA7 3.. HA7 4..
dB(A) 95 95
Figure Page
12 267
13 267
14 268
F 016 L81 056 | (18.2.15)