Saeco MOBILETTO OFFICE Uso Y Mantenimiento página 14

English
3 - SAFETY
Use the machine for its intended use only.
Do not apply technical modifications that could cause danger.
Warning
The cabinet must be used only by adults. Do not allow children to
play with the cabinet.
4 - INSTALLATION
Important
Disposal of packaging should be carried out according to
existing national laws and regulations and in line with envi-
ronmental considerations.
4.1 Positioning
For good and correct functioning, the OFFICE cabinet should be
installed near a power point and on an even surface.
5 - INSTALLING THE
LEVELING FEET
Place the OFFICE cabinet on its side and secure the supplied feet
(Fig. 1), place the cabinet in the upright position and check the
levelling.
Secure the adjustment nuts.
6 - CABINET CAPACITY
6.1 Capacity of the cup holding
tubes
The OFFICE cabinet is equipped with cup-holding tubes for large
and small cups with the following dimensions (Fig. 2).
The maximum capacity of each tube is about:
75 cups Ø 57 mm height 53 mm (small cups)
50 cups Ø 70 mm height 72 mm (large cups).
14
The overall dimensions (in mm) of the plastic cups for the tubes are
the following:
Outside diameter opening Height
57
57
70
70
70
6.2 Modifying the cup holders
According to the country where the cabinet is installed or upon
request, the cup holding setting can be changed using the cup
holders supplied (Fig. 3).
To change the cup holding setting proceed as follows:
Open the upper part of the cabinet (horizontally-pivoted).
Remove the cups that have been inserted (Fig. 4) and remove the
cup spring.
Use a screwdriver to apply pressure alternatively on the fixing teeth
(Fig. 5) and (Fig. 6) and at the same time pull the cup holder up
until the tube is disengaged.
Remove the cup holder (Fig. 7)
Remove the brushes applying pressure on the side opposite the
rabbet tooth, then turn it to remove it (Fig. 8) and (Fig. 9).
Reinstall the two brushes removed earlier on the selected cup hold-
er (Fig. 9).
Place the cup holder back in its position using a screwdriver to
apply pressure on the fixing teeth and push down to position it
(follow the disassembling procedure in reverse order).
Reinstall the conical spring with the larger diameter facing down
(Fig. 10).
6.3 Capacity of the sugar bags
tray
The dimensions in mm and the number of sugar bags to place in
the tray listed below are intended as an example (Fig. 11).
Bag dimensions
70x45 (7 grams)
6.4 Capacity of the stirrer tray
The dimensions in mm and the number of stirrers to place in the
tray listed below are intended as an example (Fig. 11).
Non-enveloped stirrer dimensions
89x9.5x1.5
53
61
72
81
91
Quantity
120
Quantity
200