1 - INTRODUCTION TO THE
MANUAL
1.1
Foreword
This manual is an integral part of the OFFICE cabinet, and must be
preserved with care. It must accompany the machine throughout
its operational life including changes of ownership. It contains all
the information about the installation and the correct use of the
cabinet for the ROYAL OFFICE coffee machine.
Always refer to this manual before performing any operation.
Manufacturer: Saeco International Group S.p.A.
Via Panigali, 39 - 40041 GAGGIO MONTANO (Bo) Italy
If this manual is lost or damaged, request a copy from an Ap-
proved Assistance Centre.
The Manufacturer reserves all copyrights on this manual.
Important
The key to open the lower part of the OFFICE cabinet is avail-
able only to the supply operator.
1.2
Symbols used
A number of symbols are used in this manual to indicate situations
that require various degrees of expertise.
Each symbol is explained by a message.
Where no symbol is used, the information is intended for all users
of the machine. The symbols used are the following:
Supply operator
Personnel in charge of cleaning and supplies only.
Maintenance operations that require a specialized technician
are not to be performed by supply operators.
Maintenance technician
The symbol indicates operations to be performed only by
specialized maintenance technicians in charge of installation
and technical assistance.
User
The person who uses the machine. Users must NOT perform
any of the tasks of the Supply operator or the Maintenance
technician.
2 - GENERAL INFORMATION
2.1
Foreword
The Royal Office machine is equipped with the following optional
components:
Coiner box
A coiner box can be attached to the machine (For further
information see the corresponding manual).
Cabinet
Made entirely of painted steel sheet, the cabinet supports
the machine and serves as container/dispenser of cups,
sugar and stirrers.
The cabinet has the following structure:
The upper part consists of a horizontally-pivoted drawer equipped
with three cup-holding tubes, a sugar bags tray and a stirrer tray.
The lower part consists of a door with incorporated lock for stor-
age.
Dimensions
The cabinet has the following dimensions:
WxHxD ............................................... 440x920x465 mm
Horizontally-pivoted door ........................................ 200 mm
Weight ............................................................. ca. 21 Kg
If necessary, contact the nearest Distributor or National Importer or
the Manufacturer when no importers are available.
APPROVED ASSISTANCE CENTERS are available for information
and explanations about the cabinet, and to provide technical as-
sistance and spare parts supplies.
The Manufacturer reserves the right to modify the machine without
any obligation to provide advance notice.
Important
Improper use of the machine determines the immediate war-
ranty expiration and the Manufacturer declines responsibility
for damages and personal injuries.
Improper use includes:
-
using the machine for purposes other than that intended
and/or following procedures not described in this
manual;
-
interventions on the cabinet that are against instructions
included in this manual;
-
using the cabinet after component parts have been tam-
pered with and/or devices have been altered.
English
13