Instructions For Overhaul Of; Disassembly - RAMSEY WINCH DC-300 Serie Manual De Funcionamiento, Servicio Y Mantenimiento

INSTRUCTIONS FOR OVERHAUL OF RAMSEY MODEL 300/H-300 SERIES RAM-LOK®
Refer to Parts List & Parts Drawing Pages for actual item numbers
and corresponding parts numbers.
1. Drain oil from gear housing by removing (item #33) plug
from bottom of gear housing. Remove plugs (items #31 &
#32) from top of gear housing. Remove mounting angles
from winch by removing hardware shown.
4. Remove motor (item #36) and coupling (item #28) from (item
#2) adapter by unscrewing two (item #23) capscrews.
Remove key (item #12) from worm shaft. Unscrew four cap-
screws (item #22) and remove adapter from gear housing.
Replace adapter seal (item #42) and gasket (item #30).
DIS-ASSEMBLY
2. Remove clutch housing (item #10) and clutch (item #5) from winch assembly.
Remove two keys (item #28) from keyways. A screwdriver can be used, at notch, to aid
in the removal of keys. Once keys have been removed, drum (item #7) and thrust washer
(item #42) can be removed from drum shaft.
3. Remove key (item #12) from worm shaft.
Remove bearing cap (item #4) and gasket (item #26)
by unscrewing four capscrews (item #19).
Remove seal (item #37) from bearing cap and press
new seal into place.
Drag brake disc (item #25) and spring (item #39)
should be examined and replaced if necessary.
9