Kapro 883N Prolaser 3D All- Lines Manual Del Usuario página 12

Working in Pulse mode with a detector:
For outdoor work under direct sunlight, or bright conditions,
and for extended indoor ranges up to 60 meters, use the
pulse mode with a Detector. When the pulse mode is
activated the laser beams will flash at a very high frequency
(Invisible to the human eye). This will allow the detector to
detect the laser beams.
1. The pulse mode can be activated only in Automatic mode.
2. Push the locking switch #1 to the ON position. The laser
level will project a 360° horizontal beam.
3. Press and hold the lines button switch #2 for 3 sec to
activate the pulse mode. Visually you can see that the
intensity of the beam is reduced a little bit.
4. Turn on the detector and search the laser beam.
5. You can choose a different beam, by briefly pressing on
the lines button switch #2, while you are in Pulse Mode.
6. To switch off the Pulse Mode, press and hold the lines
button switch #2 for 3 sec.
12