Hot Key Operation; Troubleshooting - Tripp-Lite B004-008 El Manual Del Propietario

Operation

Hot Key Operation

The following are the hot key commands for your KVM (keys must be pressed sequentially).
Change to previous port: Scroll Lock + Scroll Lock + [ ]
Change to next port: Scroll Lock + Scroll Lock + [ ]
Change to a specific port: Scroll Lock + Scroll Lock + "1" to "8" (depending on desired port)
Start Auto-Scan with an interval of "X" (where "X" can be 07, 15 or 30 for 7, 15 or 30
seconds): Scroll Lock + Scroll Lock + a + "X"
Stop Auto-Scan: Press the Space bar
NOTE: If you stop scanning on an empty port, or one where the computer is attached but is powered off, the monitor
screen will be blank, and the mouse and keyboard will have no effect. To recover, key in the Hot Key sequence (see Hot
Key Selection, above), for any Port ID that has an active PC attached.
Turn "Beep" sound On/Off: Scroll Lock + Scroll Lock + S

Troubleshooting

Symptom
Erratic Behavior
Pressing the Hot Keys does not
get a response
(Continued)
Possible Cause
Unit not receiving power under self-
powered operation
The connection from the selected
port to the target PC has been
broken, or the PC is turned OFF.
Improper KVM switch reset
Action
Use the power adapter that was
provided with the units to provide
external power.
Check the Online LED for the
selected port. If it is not lit:
1. Manually press one of the Select
switches to connect to a PC that
is powered ON.
2. Check the cables to make sure all
are properly connected.
3. If the desired PC is OFF,
power it ON
Turn OFF all KVM Switches and
wait 10 seconds before turning them
back ON.
NOTE: If the unit is operating in the
Selfpowered mode (without the
optional Power Adapter), you must
unplug the power cord of any
connected PC that has the Keyboard
'Power On' function, otherwise the
switch still draws power from the PC.
6