Avoid Paper Jams - HP Photosmart D5300 Serie Guía Básica

Ocultar thumbs Ver también para Photosmart D5300 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6.
Lower the output tray. Pull the output tray extender towards you, as far as it will go.
NOTE:
To load up to 13 x 18 cm (5 x 7 inch) photo paper in the photo tray
1.
Raise the photo tray lid to load photo paper in the photo tray.
2.
Insert the stack of photo paper into the photo tray with the short edge forward and the
print side down. Slide the stack of photo paper forward until it stops.
If the photo paper you are using has perforated tabs, load the photo paper so that the
tabs are closest to you.
3.
Slide the paper-width guide inward against the stack of photo paper until the guide
stops.
Do not overload the photo tray; make sure the stack of photo paper fits within the
photo tray and is no higher than the top of the paper-width guide.
4.
Lower the photo tray lid.

Avoid paper jams

To help avoid paper jams, follow these guidelines.
Remove printed papers from the output tray frequently.
Prevent curled or wrinkled paper by storing all unused paper flat in a resealable bag.
Ensure that paper loaded in the input tray lays flat and the edges are not bent or torn.
If you are printing labels, ensure that the label sheets are no more than two years old.
Labels on older sheets might peel off when the paper is pulled through the
HP Photosmart, and cause paper jams.
Do not combine different paper types and paper sizes in the input tray; the entire stack
of paper in the input tray must be the same size and type.
Adjust the paper-width guide in the input tray to fit snugly against all paper. Make sure
the paper-width guide does not bend the paper in the input tray.
When you use legal-size paper, leave the tray extender closed.
Avoid paper jams
37

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido