Care And Maintenance - Kenmore 119.16148110 Manual De Uso Y Cuidado

Do not clean any part of your barbecue grill in a
self-cleaning oven.
Do not use oven cleaners, abrasive kitchen
cleaners, cleaners that contain citrus products, or
mineral spirits.
Do not use any type of steel bristled brush.
Clean your grill regularly to prohibit grease build-
ups and avoid a grease fire or excessive flare-ups.
Always wear protective gloves when cleaning your
grill.
Stainless Steel and Painted Surfaces
Wash with a mild dish soap and warm water. A cloth,
soft brush, or plastic cleaning pad can be used. Rinse
thoroughly and wipe dry. There are many specific
stainless steel cleaners available. Follow the
manufacturer's directions. Always polish in the
direction of the lines. Do not allow dirt and grease to
accumulate. Do not use steel wool, as it will scratch
the surface.
In addition, the following products and naturally
occurring substances in the outdoors will damage all
stainless steel finishes. Use caution so that they do not
come in contact with your gas grill. Immediately wash
them off and dry the stainless steel should they ever
come in contact with your Gas Grill. These include, but
are not limited to, Pool Chemicals (chlorine and
bromine), Lawn Fertilizer, Ice Melting Salts, Sea or Salt
Water, Urine, Bird Droppings, and Tree Sap. Store
your grill 50 to 100 feet away from a pool as
many pool chemicals will cause rust.
Porcelain Surfaces
Use a baking soda and water solution or nonabrasive
scouring powder for stubborn stains.
Cooking Grates, Warming Rack, and Heat
Diffusers
Use a stiff brass brush. Wash with warm water and
mild dish soap as needed, rinse, and dry.
Electronic Igniter
Visually inspect for cracks. Replace if a crack is found.
Do not use water to clean the igniter.
Electronic Ignition Maintenance
Your grill is equipped with electronic ignition. It's
powered by one AA size battery. Replace the battery
when necessary. Unscrew the igniter top. Place the
new battery into the igniter with the positive (+) end
of the battery facing up. Screw the igniter top back
into place.

CARE AND MAINTENANCE

Burners
We recommend you clean your burners at least twice a
year, or before use if the grill has not been used in over
one month.
Small insects and spiders are able to access the burner
tubes. Sometimes they will build nests or spin webs. In
either case, this can block or reduce the amount of gas
flowing through the burner. You will usually see a
smaller flame, or a flame that is mostly yellow rather
than blue, coming from the burner when this happens.
Other signs include the gill not heating evenly, not
reaching temperature, or burners not igniting
cases with severe blockage, this can cause the flame
to burn backwards, and outside of the burner tubes,
which can cause damage to your grill and/or personal
injury. IMMEDIATELY SHUT OFF THE FLOW OF LP
GAS AT THE CYLINDER BY TURNING THE HAND
WHEEL CLOCKWISE SHOULD THIS HAPPEN.
Wait for the grill to cool, and then clean all burners.
23
Batteries will deteriorate over time. This
can cause their casings to leak.
•
Remove the battery from the electronic ignition
when storing your grill.
Check the condition of the battery periodically
before use.
For safe operation ensure the gas valve assembly
orifice is inside the burner tube before using your
grill. See figure. If the orifice is not inside the
burner tube, lighting the burner may cause
explosion and /or fire resulting in serious bodily
injury and /or property damage.
Gas Valve Assembly
Orifice
Burner Tube
.
In