Franke Roblin Windy Pro 900 Instrucciones De Instalación E Utilización página 10

GB
slightly to allow it to clamp around the brackets item 2. Secure the chimney stack to the brackets
using the four self tapping screws provided. Fit the lower chimney section item I by expanding the
chimney slightly to allow it to clamp around the upper chimney section item S, and the bracket on
top of the canopy item C as illustrated in fig. 5. Secure the chimney stack to the bracket using the
two self tapping screws provided.
12) Place the 3 metal grease filters as illustrated in fig. 11.
• RECIRCULATION
1) Fit the recirculation spigot item R over the round outlet on top of the canopy while pressing down on
the spigot until it snaps into position as illustrated in fig. 7.
Note : The two recirculation ducts item G must be fitted onto the recirculation spigot R before fitting
onto the canopy item C
2) Remove the metal grease filters and place one charcoal filter at a time over the grilles on either side
of the motor housing and turn clockwise into position ( A ) as illsutrated in fig. 8.
3) Fit together noise-reduction casings and charcoal filters without the plastic rings on either side of the
motor housing as illustrated in fig. 6, operation 2 .
4 OPERATION
A - EXTRACTION OR RECYCLING
Your cooker hood is supplied in the extraction mode. To use the cooker hood in the recirculation mode
re-programme the hood as follows:
Starting in the recirculation mode
Press the '+' button for 10 seconds (while the motor and lights are switched 'OFF') and the two LED lights
will flash twice to indicate confirmation that the cooker hood is in the recycling mode.
Reverting to the extraction mode
Press the '+' button for 10 seconds (while the motor and lights are switched 'OFF') and the two LED lights
will flash once to indicate confirmation that the cooker hood is in the extraction mode.
B – BASIC INSTRUCTIONS
Lighting
Press Button 1 to switch 'ON' the lights.
Motor
Press LED button 2 to switch 'ON' the fan motor, the LED F will illuminate to confirm the motor is swit-
ched 'ON', and adjust the speed of the fan motor by pressing the Button '+' and '-'. The fan speed will be
increased if constant pressure is kept on the (+) button.
8