Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
.
The relationship between the outer part of wall bracket and the attachment plates for the arm is
correct when the three "holes of sight" fits exactly linedup (centre) with the "banana formed" hole in
outer part of the wallmount. This is very important for the characteristic of the arm's movement!
If the arm is mounted high this joint can be adjusted forward, if it is mounted low do the opposite.
Note! before adjusting contact PlymoVent technical support
Outer part of
wall bracket
The position of the attachment plates against the wall bracketis correct when the two
"holes of sight" fits exactly lined up with (centre) inner "banana formed" hole. This is very
important for the characteristic of the arm's movement!
0000101888/071013/A MultiSmart Arm
Holes of sight
Spacer
Bolt hole for
securing bolt
Attachment plates
Pivot bolt
Holes of sight
EN - 10
Publicidad
Tabla de contenido
