PLYMOVENT MULTISMART ARM Instrucciones Para El Uso página 8

5. Place the arm on the axle. Place the tube(a), supplied with the extention kit on the tube-holders. Attach the hose from the arm(b)
and the hose for connecting the arm to a duct/fan(c) with hose clamps. The clamps should go underneath the tube-holders thus
keeping both tube and hose in place. If you have a MSA -XXX-3 you just put the arm on the axle.
6. Connect the arm to the ducting(d)
and adjust the friction in the outer
joint(e), by turning the allen screw.
Adjust inner joint(f) by means of
tightening /loosening the bolt, to a
suitable level of
you are now ready
to put the arm into service.
7. If you have purchased a damper kit D-XXX and wish to install it, please continue to follow the steps below. If you have purcha-
sed a halogen lamp cartridge HL-20/24-XXX and want to install it you can go to step no.11
8. Remove the stickers covering the mounting holes(a) for the damper and the hose between the hood and the outer tube(B) and
mount the "ratchet"(c) to the top of the tube using the supplied pop-rivet(d).
9. Place damper blade(a) inside outer tube(b) Put the ball cassette inside the hole in the pointy part of the damper turning knob(d)
and insert the damper shaft(c) from the top side of the tube thru the damper blade, you may have to tapp it in place with a ham-
mer. Align the knob with the damper blade in sutch a way that knob is pointing along the tube when the damper is fully open
(e) secure damper blade to the shaft with the supplied "grabber screw". Correct position of the turning knob is when there are
approximately 1mm, 0.04" between the damper ratchet and knob. Assemble in order the ponge rubber washer, spring vasher
and star-lock vasher at the damper shaft.
A
C
10. Reattach the hose between hood and outer tube. you have now completed the installation of the damper kit.
0000101888/071013/A MultiSmart Arm
friction.
A
E
B
D
C
F
B
D
B
A
D
MultiSmart MultiSmart Arm/ENG/USA/CAN/9/16 Arm/ENG/USA/CAN/9/15
® ®
E
C
EN - 7