PLYMOVENT MULTISMART ARM Instrucciones Para El Uso página 9

11. If you have purchased a halogen lamp cartridge (HL-20/24-XXX), please continue to follow the step by step instructions.
12. Remove the mesh(a) from inside of the hood. The most
efficient way to do this is to grab the mesh with a set of pli-
ers and pull it straight out. Also remove the sticker covering
the accessory holes on the hood(b).
13. Screw the switch assembly(a) to the hood with the supplied nut and
bolt(b). Push the plug that is attached to the lamp cartridge(c), from the in-
side of the hood through the rectangular hole.Fit light cartridge(d) inside
of hood. Connect the plug from the switch assembly to the plug from the
light cartridge. Excess of cable between switch assembly and light cart-
ridge can be stuffed back into the switch assembly housing.
14. Secure the power supply cable to the arm using two of the supplied plastic
fasteners(a). While doing this make sure that the length of cable between the
tube and hood(b) is long enough not to obstruct the movement of the hood.
Attach the rest of the cable to the arm with the remaining plastic fasteners and
the self adhesive anchors . you have now completed the installation
of the halogen lamp kit.
0000101888/071013/A MultiSmart Arm
A
B
D
MultiSmart MultiSmart
A
B
C
A
B
Arm/ENG/USA/CAN/10/16 Arm/ENG/USA/CAN/10/15
® ®
EN - 8