Personal Worksurface Replacement; Side Surface Removal - Steelcase 488 Brody Manual Del Usuario

®
Personal Worksurface
Replacement
NOTE: This assembly assumes any
screens and top caps have already been
removed.
1.
Using a T30 torx bit, remove (2)
screws (T30 TORX) underneath (1a).
Using a T40 torx bit, remove one (1) screw
(T40 TORX) from the side (1b). Using a
T40 torx bit, remove two (2) screws (T40
TORX) on top and to remove the personal
worksurface (1c).
2.
Carefully slide the personal
worksurface out from underneath the side
surface.
NOTE: Do not load the side surface with
the personal work surface removed.
3.
Reverse steps 1 and 2 to install new
personal worksurface.
T40 TORX
1c
1a
T30 TORX
SIDE SURFACE
1b T40 TORX
Page 10 of
113157