EGAmaster 79658 Manual De Instrucciones página 57

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Adjusting the saw blade guide
Loosen the tension lever item 22 and feed the saw blade guide item 21 as far as possible
along the workpiece (see item 7).
Tighten the tension lever item 22.
Changing the cutting angle
Before adjusting the tool, imperatively disconnect the pneumatic and depressurize the motor
by pressing the valve trigger once.
The cutting angle can be adjusted steplessly from 0° to 45°.
Loosen the tension lever item item 13 and set the swivel support item 11 to the required
cutting angle.
Use the scaling on the clamp as an adjustment aid.
Retighten the tension lever item 13.
Changing the saw blade
Observe the following safety instructions before changing the saw blade.
WARNING – Before adjusting the tool, imperatively disconnect the pneumatic
and depressurize the motor by pressing the valve trigger once.
Fig. 7
Fig. 8
57

Publicidad

Tabla de contenido
loading

Tabla de contenido