EGAmaster 79658 Manual De Instrucciones página 73

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

The following table shows possible problems and their causes:
Problem, cause, remedy
Problem
Cut is not
satisfactory, though
a
the motor runs
properly
b
Vibration
Pneumatic band
saw does not run
c
.
Pneumatic band
saw runs too slowly.
d
Other problems
We ask you to send the machine to the manufacturer, if necessary.
TROUBLESHOOTING
Cause
Saw blade is not sharp.
Teeth point to the wrong
direction.
Saw blade is not tightened.
Saw blade type (material, tpi) is
wrong for cutting the material.
Cutting speed of the saw blade is
wrong.
Material to be cut is not firmly
fixed.
Saw blade type (material, tpi) is
wrong for cutting the material or it
is dull.
Not connected to compressed air.
Insufficient air supply.
Iced sound absorber.
Clogged sound absorber.
Too little operating pressure
Hose diameter too small
Too little volume flow.
-
Remedy
Install new saw blade.
Remove saw blade, change
teeth direction and install it
again.
Tighten saw blade.
Replace saw blade.
Increase or decrease
operating pressure.
Clamp the material near the
cutting location.
Replace saw blade.
Connect and open the
compressed air supply.
Check compressor and stop
valves.
Additionally check the
screen and the air inlet of the
machine.
Let defrost and use antifreeze
lubricant in future.
Clean and replace.
Increase operating pressure
Choose larger hose diameter
Increase volume flow.
Contact authorized expert
company
73

Publicidad

Tabla de contenido
loading

Tabla de contenido