EGAmaster 79658 Manual De Instrucciones página 77

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Remove snap ring N from the end plate O. Press out the groove ball bearing P (see fig. 7).
Re- assembly of the motor
Basically the re-assembly is done in reverse order than the disassembly. Wear parts,
especially the vanes, have to be replaced. The vanes Q are considered to be worn, when their
width is less than 7,2 mm (see fig. 8).
Disassembly of the handle
Loosen the socket head screws R and remove the handle S from the motor housing M (see
fig. 9).
77

Publicidad

Tabla de contenido
loading

Tabla de contenido