Nice Era Fit MHT Instrucciones Y Advertencias Para La Instalación Y El Uso página 5

A - First transmitter
A transmitter can be memorised as a first transmitter only if in the motor no
other transmitter is memorised. For this memorisation, follow procedure 5.5 (this
memorises the transmitter in "Mode I".
B - Second (or third, fourth, etc.) transmitting device
A portable transmitter (or a radio climate sensor) can be memorised as a second
(or third, fourth, etc.) transmitting device only if the First Transmitter is already
memorised in the motor. For this memorisation, follow one of the procedures
given in section 5.9.
5.4.3 - Two procedures to memorise the keys of a transmitter
To memorise the keys of a transmitter, two different procedures can be used: "Mode
I" and "Mode II".
• "MODE I" – This mode automatically transfers, the various commands available in
the motor, all together, into the various keys available on the transmitter, without
allowing the installer to change the combinations of commands and keys. Upon
completion of the procedure, each key will be combined with a command accord-
ing to the following diagram.
- key s (or key 1): will be combined with Raise
- key n (or key 2): will be combined with the command Stop
- key t (or key 3): will be combined with the command Lower
(if there is a fourth key on the transmitter .....)
- key 4: will be combined with the command Stop
Note – If the keys of your transmitter have no symbols or numbers, see fig. 2 to
identify them.
Application types and operating requirements
Vertical roller awning
Limit switch programming:
Functions available...
Arm awning Limit switch programming:
Functions available...
( )
"1"
"S"
( )
"1"
"S"
• "MODE II" – This mode allows you to manually combine one of the commands
available in the motor with one of the transmitter keys, giving the installer the option
of choosing the command and key combinations to use. At the end of the proce-
dure, to memorise another key with another command desired, it will be necessary
to repeat the procedure once again.
Warning! – Each automation has its own list of commands that can be memorised
in Mode II; in the case of the present motor the list of commands available is given
in procedure 5.9.2.
5.4.4 - Number of transmitters that can be memorised
You can memorise 30 transmitters (including any radio climate sensors) if these are
all memorised in "Mode I", or you can memorise 30 single commands (keys) if they
are all memorised in "Mode II". The two modes can coexist up to a maximum limit
of 30 memorised units.
• with automatic stop in the upper limit
switch position "0" (with box)
• without containment mechanical con-
straints in the upper limit switch "0"
...if it is necessary to reduce the impact
force when closing
• with automatic stop in the upper limit
switch position "0" (with box)
• without containment mechanical con-
straints (square bar or similar)
...to stretch the canvas: "FRT" function
...if it is necessary to reduce the impact
force when closing
Recommended programming
Programming in semiautomatic mode (paragraph 5.7)
Programming in manual mode (paragraph 5.6)
Adjustment of the motor traction force ("RDC" function –
paragraph 5.11)
Programming in semiautomatic mode (paragraph 5.7)
Programming in manual mode (paragraph 5.6)
Programming the "FRT" function (paragraph 5.12)
Adjustment of the motor traction force ("RDC" function –
paragraph 5.11)
English – 4