GreenWorks 1400102 El Manual Del Propietario página 12

OPERATING YOUR POLE SAW
ADDING BAR AND CHAIN LUBRICANT (See Figure 3)
Use GREENWORKS Bar and Chain Lubricant. It is designed for chains and chain oilers, and is
formulated to perform over a wide temperature range with no dilution required.
NOTE: Pole saw comes from the factory with no bar and chain oil added. Level should also be checked after
• Remove oil cap.
• Carefully pour the bar and chain oil into the tank.
• Wipe off excess oil.
•
• Repeat as needed.
NOTE: Do not use dirty, used or otherwise contaminated oils. Damage may occur to the bar or chain.
NOTE: It is normal for oil to seep from the saw when not in use. To prevent seepage, empty the oil tank after
each use then run for one minute. When storing the unit for a long period of time (three months or longer) be
sure the chain is lightly lubricated; this will prevent rust on the chain and bar sprocket.
I M P O R T A N T
To preserve natural resources, please recycle or dispose of oil properly. Consult your local waste
authority for information regarding available recycling and/disposal options.
Quick View
Oil Indicator
12
Oil Reser-
voir Cap
Fig. 3