GreenWorks 1400102 El Manual Del Propietario página 16

OPERATING YOUR POLE SAW
ADJUSTING TELESCOPING POLE (See Figure 6)
• Remove the battery pack from the pole saw.
• Rotate the collar counterclockwise to loosen.
• Push poles towards each other to shorten the pole or pull away from each other to lengthen
the pole.
NOTE: Extend the pole only to the length required to reach the limb being cut. Do not extend the handle
above waist height.
• When the desired length is achieved, rotate the collar clockwise to secure.
NOTE: Adjust hand placement on the shaft of the pole saw to keep proper balance. Do not attempt to use the
pole saw at a length which does not allow you to achieve proper footing and balance at all times.
ASSEMBLING THE POLES (See Figure 6)
• Remove the battery pack from the pole saw.
• Insert handle pole into intermediate pole or powerhead pole firmly.
• Turn the collar clockwise to lock the poles together.
NOTE: Assemble poles only to the length required to reach the limb being cut. Do not extend the handle
above waist height.
NOTE: Adjust hand placement on the shaft of the pole saw to keep proper balance. Do not attempt to use the
pole saw at a length which does not allow you to achieve proper footing and balance at all times.
Collar
Fig. 6
16