GreenWorks 1400102 El Manual Del Propietario página 20

MAINTENANCE
CHAIN OILER (See Figure 20)
W A R N I N G
To avoid possible serious injury, stop the motor and remove the battery from the pole saw
before replacing the bar, chain, or performing any maintenance operation.
• Use Premium Bar and Chain Lubricant. It is designed for chains and chain oilers and is
formulated to perform over a wide temperature range with no dilution required.
• Remove the cap and carefully pour approximately 2 oz (57 g) of bar and chain lubricant into
the bar lube reservoir.
• Replace the cap and tighten securely.
•
NOTE: Do not use dirty, used, or otherwise contaminated lubricants. Damage may occur to the oil pump, bar,
or chain.
the foam.
Remove
Cap
20
Bar Lube Reservoir
Fig. 20