Shindaiwa T242 Manual Del Usuario página 7

Assembly and Adjustments
Cutting Attachment Shield
Socket-
Head Cap
Screw
Bracket
Shim
Clamp
Screw
Retaining
Nut
Figure 9
Install the Cutting Attachment
Shield T242/T242X.
1. Insert the cutting attachment shield
between the outer tube and the cutting
attachment mounting plate.
See Figure 9.
NOTE:
It may be necessary to loosen the
retaining nut and clamp screw to adjust
cutting attachment shield mounting plate.
. Fit the two shims and the bracket over
the outer tube and loosely install the
four socket-head screws. See Figure 9.
CAUTION!
Make sure the clamp screw and
retaining nut are securely tightened
before tightening the four socket-head
cap screws.
Assembly
Trimmer Head
Output
shaft
Figure 10
Install the Trimmer Head.
1. Turn the trimmer over so that the gear
case output shaft faces UP.
. Remove and discard the black plastic
protective cap from the output shaft.
See Figure 10.
3. Rotate the holder until the hole in the
holder aligns with the notch on the
gear case. Use the long end of the hex
wrench to lock the holder and output
shaft. See Figure 10.
4. While holding the hex wrench, thread
the trimmer head onto the output shaft,
turning counter-clockwise. Using hand
pressure only, tighten the trimmer head
firmly on the output shaft.
Outer
Tube
Line Cutter
Shim
Cutting
Attachment
Mounting
Plate
Figure 9A
3. Tighten the four socket-head cap
screws to secure the cutting attachment
shield.
4. Re-tighten clamp screw and retaining nut.
out the cutting attachment shield
installed and tightly secured!
Sub-Shield T242X
(when trimmer head is in use)
1. Attach the shield extension to the
cutting attachment shield.
without sub-shield when using a
trimmer head.
Retaining
Plug
Holder
Hex Wrench
The trimmer head has a left-hand thread.
For removal turn the trimmer head
clockwise.
5. Remove the hex wrench.
6. Adjust the trimmer line length to reach
no further than the line cutter on the
cutting attachment shield. Trim to the
correct length if necessary.
completely assembled and ready
for use with a trimmer head.
T242
Cutting
Attachment
Shield
Nuts
26013
Hex
Screws
WARNING!
NEVER operate the unit with-
WARNING!
NEVER use this machine
IMPORTANT!
The unit should now be
Bolt
Upper Clamp
Shim
Shim
Nut
Cutting Attachment Shield
Cutting Attachment Shield
Sub-shield
CAUTION!
Make sure the sub-shield is completely
hooked at the hook receiver.
To install a
trimmer head onto
a T242X, first
remove the
shaft bolt, bolt guard
and safety clip
(see the next page).
Figure 11
WARNING!
A standard grass trimmer
with a loop handle should NEVER be
operated with blade-type attachments.
For blade use the trimmer must be
fitted with a bicycle-type handlebar
or a barrier bar that is located in front
of the operator to reduce the risk of
the operator from coming in contact
with the cutting attachment (per ANSI
B175.3). When using a blade, the unit
must also be equipped with a harness
or strap.
T242X
Hook
Receiver
Hook
7