Connecting And Charging; Using Your Toothbrush - Braun Oral-B PROFESSIONAL CARE TRIUMPH 5000 Manual De Instrucciones

Ocultar thumbs Ver también para Oral-B PROFESSIONAL CARE TRIUMPH 5000:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Specification
For Mexico only:
Type: 3757
Voltage: 110 – 130 V ~
Frequency: 50 – 60 Hz
Power: 0.9 W
Noise level:
65 dB (A)
IP: 67
For voltage specifications for any other country, please
refer to the bottom of the charging unit.

Connecting and charging

• Plug the charger into an electrical outlet. For
voltage specifications refer to the bottom of the
charging unit.
• The flashing green lights indicate that the tooth-
brush is charging (picture 1, page 5); once it is
fully charged, the lights turn off. A full charge can
take up to 24 hours and enables up to 10 days of
regular brushing (twice a day, 2 minutes).
Note: If the green lights do not flash immediately,
continue charging. They will appear in 10–15
minutes.
• If the rechargeable battery is low the red low
charge indicator light is flashing for some seconds
when turning your toothbrush on/off. If the
rechargeable battery is empty the motor will stop;
it will need a 40-minute charge before you can use
it for a 2-minute brushing.
• For everyday use, the toothbrush handle can be
stored on the charging unit to maintain it at full
power. Overcharging is impossible.
• To maintain the maximum capacity of the
rechargeable battery, unplug the charging unit
and fully discharge the handle with regular use
at least every 6 months.
SmartGuide adjustments
The SmartGuide (i) comes with a demonstration
mode. Deactivate this mode by removing the
compartment cover in the back (picture A, page 4)
and push the «set» or «h/min» button. A flashing
«12:00» indicates that you can now adjust the clock
time.
Note: If the SmartGuide display is blank before first
use (no active demonstration mode/no batteries
inserted) the batteries will need to be replaced/
inserted before continuing.
Batteries are supplied.
Clock Time
Press and hold the «set» button until «12h» is
displayed. By briefly pressing the «h/min» button,
you can toggle between «12 h» or «24 h» daytime
18
format. Push «set» to confirm your choice. Then the
hour digit starts flashing. Press the «h/min» button
until the right hour appears and confirm with «set».
Proceed same way to set both minute digits
(picture B, page 4).
SmartGuide Icons
Displayed
Meaning
Icon
«Daily Clean»
«Deep Clean»
«Sensitive»
«Whitening»
«Massage»
Too much pressure is applied.
Reduce the brushing force.
«Quadrant circle»
Move to the next quadrant of your
mouth when the relevant segment
flashes.
You reached the dentist recom-
mended 2-minute brushing time
(3-minute brushing time within the
Deep Clean mode).
After use you will receive a star with
each completed quadrant.
Smart Guide Batteries are low.
Change batteries of the SmartGuide.

Using your toothbrush

Brushing technique
Wet brush head and apply any kind of toothpaste.
To avoid splashing, guide the brush head to your
teeth before switching the appliance on (c). Guide
the brush head slowly from tooth to tooth, spending
mode
mode
mode
mode
mode

Publicidad

Tabla de contenido
loading

Tabla de contenido