Caller Setting; Gate; Volume; Brightness - Marmitek DOORPHONE 210 Manual Del Usario

The power indicator (20) will light up blue. In case the Li battery has run
down, the power indicator will start flashing blue. At the same time, the
battery icon
Place the unit into the charger stand to charge up the battery.
During standby mode, a short press of the Talk/answer
button / (16) will initiate communication with the
door unit and wake up the screen (18) showing the
view as captured by the lens (6) (In case a backgate
caller unit has been installed, the screen (18) will
prompt you to select "FRONT" or "BACK". Use the
left/right key (9) (10) to select and menu key
to confirm.).
Long touch the menu key
show the menu on the screen (18):
Use the left/right key
parameters to be set, then short touch the menu key
(11) to confirm. The selectable values now show
yellow while the parameter description resumes the
light blue colour.

9 Caller setting

9.1

Gate

This will select the door unit you prefer to change the
settings for. Use the left/right key
between FRONT or BACK gate, then short touch the
menu key (11) to confirm your setting.
9.2

Volume

This will set the speaker volume of the door unit. Use
the left/right key
levels with 1 being the lowest and 5 being the highest volume. Short
touch the menu key
9.3

Brightness

This will set the brightness of the visitor's image as shown on the screen
(18). Use the left/right key
1 being the lowest and 5 being the highest brightness. Short touch the
menu key (11) to confirm your setting.
12
shown on screen (18) will become empty and flashing.
(11) for over 2 sec to
(9) (10) to select the
(9) (10) to select between the 5
(11) to confirm your setting.
(9) (10) to select between the 5 levels with
(11)
(9) (10) to select
© MARMITEK