Contrast; Gate Light; Alarm Mode; Door Lock Open - Marmitek DOORPHONE 210 Manual Del Usario

9.4

Contrast

This will set the contrast of the visitor's image as shown on the screen
(18). Use the left/right key
1 being the lowest and 5 being the highest contrast. Short touch the menu
key (11) to confirm your setting.
9.5

Gate light

For the door unit installed at a location where there is not enough
illumination even at day time, this function can be used to switch on the
white LED every time the call button
as a back-up light to illuminate the face of your visitor.
Use the left/right key
Short touch the menu key
ON: gate light always on once the call button
OFF: gate light always off.
AUTO: gate light will go on, once the call button
when the light sensor (5) detects a low light intensity.
After completing the settings, select RETURN to go back to the main
menu.
9.6

Alarm mode

This will set the method of alert when a visitor calls, either with a ding-
dong sound or vibration or both. Use the left/right key
between (ding-dong sound and vibration) or
only) or (vibration only). Short touch the menu key
The corresponding icon will be shown on the top of the screen (18). In
case blank is selected, no ding-dong sound and vibration alert will be
provided; only the visitor's image will be shown on the screen (18) when
someone calls.
9.7

Door lock open

This is to activate or deactivate the door lock open key
left/right key (9) (10) to select between "ACTIVATE" or
"DEACTIVATE", Short touch the menu key
DEACTIVATE is selected, the icon
screen (18).
9.8

Trigger time

This is the duration time for how long the door lock is being triggered. Use
the left/right key
Short touch the menu key
Video DoorPhone 210
(9) (10) to select between the 5 levels with
(9) (10) to select between ON, OFF or AUTO.
(11) to confirm.
(9) (10) to select between 2, 5, 10, 20 or 25 seconds.
(11) to confirm.
(1) is being pressed which serves
(1) is pressed.
(1) is pressed and
(ding-dong sound
(11) to confirm.
(11) to confirm. In case
will show up at the top part of the
(9) (10) to select
(13). Use the
13