Electrical Connection Diagram; Operation Modes - Astralpool 54092 Manual De Instalación Y Mantenimiento

The Projector RGB if it needs control for the change of colour and of sequences.
5. CONTROL SYSTEMS OF THE LED LAMP:
The LED lamp can be controlled in two different ways: either by a normally closed pushbutton or by means of the modulator and/or remote
control
In both cases, you should make sure that the voltage received by the lamp is never more than 12V.
The lamp should only be operated underwater and anchored to the vertical walls of the pool. The lamp is supplied with heat protection, which in
the event of excess temperature reduces the lighting level to avoid overheating.
5.1. COLORPLUS ECO: pushbutton control
The system has 14 operation modes: 7 set colours and 7 sequences of different colours (see section 6.1.2.) The colour or sequence is
changed by a quick press of the pushbutton. The lamp/s is/are placed in white if the pushbutton is pressed for longer.

5.1.1. Electrical connection diagram

The COLORPLUS ECO system is composed of the projector/s, the transformer and the normally closed (NC) pushbutton.
The transformer must be able to supply 60VA for each led lamp connected. For example, if you want to control 5 lamps, you must connect
them in parallel to a transformer of at least 300VA. The pushbutton must be able to withhold the power consumed by the number of lamps
installed.

5.1.2. Operation modes

The COLORPLUS ECO unit enables different light scenarios to be created inside the swimming pool with two operation possibilities:
Set colour: Selection of one set colour out of seven possibilities.
Automatic sequence of colours: Selection of seven colour sequence programmes. Each programme is defined by the lighting time of each
colour and the transition time from one colour to another according to the following table:
The colour or sequence is changed by pressing the pushbutton. The colour and sequence cycle is rotary. For example, if you are in colour 6,
by pressing once, you will reach colour 7. If you press once again, you will go to sequence 1. If you are in sequence 7, press once and you will
get to colour 2, which is Red.
Colour 1, corresponds to white and is reached by one long press.
5.2. COLORPLUS TOP: Modulator control and/or Remote control
The system has 20 operation modes: 12 set colours and 8 sequences of different colours (see section 6.2.2.).
The Modulator controls switching the lamps on and off, changes of colour and sequences and switching off timing.
If you have a remote control, apart from the Modulator operations, you can also switch colours of a sequence on and off and select the
switching off time.
A T T E N T I O N
The Projector only white light not need any control since it emits.
COLOUR Nº
SEQUENCE
1 Red
2 Red
3 Purple
4 Red
5 Purple
6 Yellow
7 Green
COLOUR
1 White
2 Red
3 Blue
4 Green
5 Purple
6 Cyan
7 Yellow
ORDER OF COLOURS
Blue Green Purple
Green Cyan Blue
Cyan Yellow -
Blue Green -
Cyan Yellow -
Purple Cyan -
Red Blue -
3
Cyan Yellow
Purple Yellow
- -
- -
- -
- -
- -