Troubleshooting - Danby Designer DUF138E1WDD Guía Del Proprietario De Utilizacion Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Troubleshooting

Occasionally, a minor problem may arise, and a service call may not be necessary - use this troubleshooting guide for
a possible solution. If the unit continues to operate improperly, call an authorized service depot or Danby's Toll Free
Number for assistance.
PROBLEM
Does not work
Freezer runs continuously
Internal temperature not cold
enough
Temperature inside the unit is
too cold
Noises coming from the unit
(popping, cracking, gurgling)
Error Codes:
E2: Freezer temperature sensor failure.
E5: Freezer defrosting sensor failure.
E6: Communication failure.
E7: Ambient temperature sensor failure.
E9: Freezer high temperature.
Tel: 1-800-26-
POSSIBLE CAUSE
No power to unit
Power cord is unplugged
Wrong voltage is being used
Temperature set too low
(cold)
Lid is not closed
Hot food was inserted
Lid opened too long or too
often
Close proximity to heat
source or direct sunlight
Quick Freeze function is set
No power to unit
Power cord is unplugged
Temperature set too high
(warm)
Lid is not closed
Hot food was inserted
Lid opened too long or too
often
Air fl ow obstruction
Wrong voltage is being used.
Close proximity to heat
source or direct sunlight
The temperature control is set
too cold
Parts are expanding and
contracting.
Refrigerant is circulating in
the system
9
(1-800-263-2629)
Check connection of power
cord to power source
Plug in unit
Use proper voltage
Set temperature control to
warmer setting
Close lid securely
Be sure food is at room tem-
perature before inserting
Minimize lid openings / dura-
tion
Do not place unit close to
heat sources or direct sun-
light
This is normal
Check connection of power
cord to power source
Plug in unit
Check setting and adjust as
needed
Close lid securely
Be sure that food is at room
temperature
Minimize lid openings / dura-
tion
Allow room for air to circulate
around unit
Use proper voltage
Do not place unit close to
heat sources or direct sun-
light
Adjust the temperature set-
ting
This is normal
This is normal
SOLUTION

Publicidad

Tabla de contenido
loading

Tabla de contenido