Installation - Tripp-Lite AG-00E1 Serie Manual Del Propietário

Installation

1A
Zero U Rack Configuration. Attach the two mounting
clips supplied with the PDU to the rack enclosure using
the included hardware. The mounting clips should be
attached along a vertical plane at equidistant points which
roughly correspond to the center and ends of the PDU.
The exact mounting configuration may vary depending on
the rack and enclosure. If possible, use pre-existing
mounting points within the enclosure.
1B
Wall or Under-Counter Configuration. Attach the two
mounting clips supplied with the PDU to a wall or similar
flat, secure surface using the included hardware. The
mounting clips should be attached along a vertical or
horizontal plane at equidistant points which roughly
correspond to the center and ends of the PDU. If
possible, use pre-existing mounting points. WARNING: Do
not attempt to mount the PDU with the outlets facing
downward; the mounting clips are not designed to
support the weight of the PDU in that manner.
1C
Zero U Rack Configuration. For toolless mounting:
Position the PDU as desired in the rack enclosure, align
the buttons with the rack mounting slots and slide the
PDU into position.
Note: Mounting buttons come preinstalled with select
models.
Note: Regardless of configuration, the user must
determine the fitness of hardware and procedures before
mounting. The PDU and included hardware are designed
for common rack and rack enclosure types and may not
be appropriate for all applications.
2
Attach the PDU to the mounting clips. Using an
assistant, place a rear corner of the PDU on the inside
edge of the mounting clips, pivot the PDU toward the
alternate inside edge and snap into place.
3
Attach the input plug of the PDU to a grounded
outlet. Insert the plug directly into a grounded outlet that
does not share a circuit with a heavy electrical load (such
as an air conditioner or refrigerator).
4
Attach equipment to the PDU. Do not exceed the load
rating of the PDU. The total electrical current used by the
PDU will be displayed on the digital meter in amperes.
5
Optional Installation (Models PDUMV20-24,
PDUMV20-36 and PDUMV20-72). The PDU includes an
adapter that converts the L5-20P input plug to a 5-20P
input plug. The adapter is optional; the PDU will work
properly without connecting the adapter.
14-08-092-933381.indb 3
1A
1B
1C
2
3
3
4
5
3
PDUMV15-24
and PDUMV15-36
PDUMV20-24, PDUMV20-36
and PDUMV20-72
PDUMV20-24, PDUMV20-36
and PDUMV20-72
8/21/2014 10:27:54 AM