Bissell PROHEAT 2X REVOLUTION 1548 Serie Guia Del Usuario página 11

Cleaning Your Carpet
1
Plug into
a properly
grounded outlet.
4
Max Clean & Deep Clean Modes:
Standard Cleaning
1. Press the Spray
Trigger to apply
solution while making
2 slow, wet passes
(1 forward, 1 back).
2. Release the Spray
Trigger.
3. Make 2 slow, dry
passes (1 forward, 1
back) to suck up the
dirty solution. Do
not hold down the
trigger for this step.
CLEANING TIPS:
» To prevent damage to Berber carpets, avoid repeated strokes in the same area.
» For best cleaning performance, clean with your machine in Deep Clean Mode.
» Choose Deep Clean Mode and use BISSELL Deep Clean + Antibacterial to deliver
antibacterial benefits.
» Max Clean Mode is intended for your dirtiest carpeted areas. Dry time is an estimated
8 hours. To expedite the drying process, place a fan in the room or near the carpet.
» In Express Clean Mode, the Dirty Water Tank will not get as full as when cleaning with
Deep or Max Clean Mode.
» It is common to refill the Clean Water Tank and empty the Dirty Water Tank multiple
times during the cleaning process. Room size and the speed at which you clean both
affect how often the tank may need to be refilled and/or emptied.
2
Select Cleaning Mode
Max Clean
» Provides a heavy cleaning for
your dirtiest carpets.
» Dry Time: About 8 hours.
Deep Clean
» Delivers a deep clean to your
carpet.
Express Clean
» Provides a lighter clean.
» Dry Time: About 30 minutes.
» Recommended Cleaning
Pace: 12 inches per second
Using BISSELL® Deep Clean
+ Antibacterial Formula
1. Press the Spray Trigger
to apply solution while
making 3 slow, wet
passes (1 forward,
1 back, and 1 forward
again).
2. Release the trigger.
3. Make 1 slow, dry pass
back to suck up the
dirty solution. Do not
hold down the trigger
for this step.
3
Press the Power Switch
to turn the machine ON.
To recline your machine
for use, press the recline
pedal with your foot.
Express Clean Mode:
1. Press the Spray Trigger
to apply solution while
making 2 wet passes
(1 forward, 1 back).
2. Release the Spray Trigger.
3. Make 2 dry passes (1
forward, 1 back) to suck
up the dirty solution.
Do not hold down the
trigger for this step.
www.BISSELL.com
11