Important - Bissell PROHEAT 2X REVOLUTION 1548 Serie Guia Del Usuario

Cleaning Area Rugs
IMPORTANT: Please check manufacturer's tag before cleaning area rugs for any
specialized cleaning instructions. We do not recommend deep cleaning delicate, silk,
wool, antique, or area rugs without a manufacturer's tag.
Regularly clean your high-traffic area rugs in Express Clean Mode:
» Check the manufacturer's tag.
» Select Express Clean Mode.
» When cleaning area rugs, place the rug on a sealed surface to test for colorfastness in
an inconspicuous area. Your cleaner should not be used on unsealed surfaces.
» Important: Keep the foot of the deep cleaner perpendicular to the rug's edge with
each cleaning pass to prevent damage.
Cleaning with Hose and Tool
» Keep hair, loose clothing, fingers, and all
parts of body away from openings and
moving parts. The Brush Roll continues
to rotate when in the upright position.
» The Brush Roll continues to turn while
product is turned on and handle is in
upright position. To avoid damage to
carpet, rugs, furniture, and flooring,
avoid tipping cleaner or setting it on
furniture, fringed area rugs or carpeted
stairs during tool use.
» With Brush Roll on, do not allow cleaner
to sit in one location for an extended
period of time, as damage to floor can
result.
2
Insert the hose and
snap into place.
Be sure the colored
hose release clip
is facing out, away
from machine.
3
Attach the tool to the end of the hose.
(Tools may vary by model.) Press the
Power Switch to turn machine ON.
NOTE: If using the Mini Deep Reach Tool, be sure the needles of the tool are pressed
down into the carpet so the spray gets into the carpet fibers.
12
www.BISSELL.com
1
Lift the Accessory Hose Door on top of
foot on the front of the machine. The
door flips toward the machine to open.
4
Press the Spray Trigger button to spray
the soiled area, then slowly move tool
back and forth over the area.
Release the trigger to suck up the dirty
solution. Work in small sections until the
area is clean.
When finished cleaning, turn the machine
ON to suction up warm clean water to
rinse the inside of the hose and tool.
Detach the hose and tool and close the
Accessory Hose Door. Let the hose and
tool air dry before storing.