Bissell PROHEAT 2X REVOLUTION 1548 Serie Guia Del Usuario página 16

Cleaning the Brush Rolls
1
Turn OFF and unplug the
machine.
Replacing Belts or Brush Rolls
What you will need: 1 Phillips-head screwdriver & 1 flat-head screwdriver
1
Unplug the machine. Remove both tanks
from the machine. Press the recline pedal
and lay the machine on its back. Use a
flat-head screwdriver to help lift and
remove the Belt Access Door.
2
Here you should see one (1) belt.
This is the Flat Pump Belt. If the
Flat Pump Belt is broken, gently
remove it from the machine. We
will replace this belt in Step 5.
4
Remove the Brush Cover by
lifting straight up. Remove the
Cogged Large Pump Belt. The
Brush Rolls can be replaced or
cleaned at this time, if needed.
16
www.BISSELL.com
2
Lay the machine down
on its back or side.
3
Turn the machine on its side. The Power Switch
should be facing up. Remove the 3 screws on
the Belt/Brush Access Plate using a Phillips-head
screwdriver. Remove the Access Plate to expose
the Brush Cover and Cogged Large Pump Belt.
3
Use the comb to brush
out the debris or hair from
the Brush Rolls.