Bissell PROHEAT 2X REVOLUTION 1548 Serie Guia Del Usuario página 13

Cleaning with the Bare Floor Tool*
*The Bare Floor Tool that is compatible with the ProHeat 2X® Revolution™ is not
included. It is available for purchase by contacting our team by phone or visting us
online at BISSELL.com.
1
With the machine unplugged,
attach the Bare Floor Tool to
the bottom of the machine by
lining the tool to the edge of
the nozzle. Rotate down until it
clicks into place.
Follow filling instructions on
pages 9 and 10 and switch
Cleaning Mode to Express Clean.
WARNING
To reduce the risk of fire and electric shock when cleaning a hard floor, the BISSELL® Bare Floor Tool
(1606611) must be used and is only to be used with BISSELL Hard Floor Formulas intended for use with
this appliance.
2
Plug into a properly
grounded outlet and
press the Power Switch.
Clean by pressing the
trigger for 1 wet pass
forward, 1 wet pass
back. Then release
the trigger and make
1 dry pass forward,
1 dry pass back.
Recommended Pace:
12 inches per second
3
When finished,
unplug the machine
and remove the
Bare Floor Tool by
rotating the tool up
to unhook from the
nozzle.
Rinse and let dry
before storing.
Refer to page 14
for "Emptying the
Dirty Water Tank".
Refer to page 15 for
"Cleaning Machine
After Use".
www.BISSELL.com
13