Emptying The Dirty Water Tank - Bissell PROHEAT 2X REVOLUTION 1548 Serie Guia Del Usuario

Emptying the Dirty Water Tank

WARNING
To reduce the risk of fire, electric shock or injury, turn power OFF and disconnect plug from electrical
outlet before performing maintenance or troubleshooting.
1
To release Dirty Water
Tank, press down on the
colored tank Handle.
4
14
www.BISSELL.com
2
Tilt the tank slightly toward
you. Grab the handle and
tank with both hands.
For quick empty:
Pull the rubber tab
(located in the middle
of the tank) and tilt to
pour.
When closing the
rubber tab, make
sure all edges are
sealed tight.
For final clean and
rinse: Unscrew the ring
at the bottom of tank.
Gently remove the Float
Stack, rinse,
and clean.
Once clean, return Float
Stack into the tank by
lining up the arrows
so they point at each
other. This is the only
way the Float Stack will
fit into the tank.
With the arrows
aligned, the Float Stack
should lock into place.
Return the ring and
twist to lock. Water
may leak if the ring is
not fully tightened.
3
Pull Dirty Water Tank up
and away to remove.
5
Clean the red filter
below the Dirty
Water Tank by wiping
off any remaining dirt
or debris.
6
To return the Dirty
Water Tank: Angle
the tank and insert
bottom first. Then
tilt the tank toward
the machine and
push the top in until
it clicks into place.
Did You Know?
The Float Stack is
what prevents
your Dirty
Water Tank from
overflowing.