WD Plus Bearware 303456/20191119HK016 Manual Del Usuario página 21

6. DCF signal
You can enable (auto) or disable (off) this function as the last item in the basic
settings.
The DCF signal is a time signal which is sent out by one of the most accurate clocks
in the world. It is located near Frankfurt am Main. Under ideal conditions, your
weather station can receive the signal from a distance of up to 1500 km.
If the weather station has detected the signal, then it displays the current Central Eu-
ropean Time, the date, and the day of the week depending on the basic settings. The
DCF symbol " " is then shown on the display.
The weather station scans for a signal and attempts to synchronise every day at
02:00, 08:00, 14:00 and 20:00 hrs.
You can start the signal scan automatically by pressing the "RCC" button in the
battery compartment of the outdoor sensor.
Once the attempt to receive a signal fails, the weather station stops scanning after
about 5 minutes. The DCF symbol disappears from the display.
Caution! Remember that some devices may be sources of interference for receiving
the signal, such as televisions, computers, etc. You may have problems in receiving
the signal in closed areas such as an airport, factories, cellars etc.
7. Basic settings:
Note: When the backlight is switched off ("backlight" switch in Off position),
the backlight can be turned on for approximately 5 seconds by pressing the
large "SNOOZE / LIGHT" button on the top of the housing.
Press and hold the "TIME" button for about 5 seconds to configure the basic
settings. With the "CH/+" and " _ " buttons you can change the values accordingly.
By briefly pressing the "TIME" button, you can confirm the entry and proceed to
the next option. In this way, you can change and customise the following settings
in the sequence mentioned below:
English
21