Alarm Setting - WD Plus Bearware 303456/20191119HK016 Manual Del Usuario

• 12/24 hour format
• Hour
• Minute
• Second
• Year
• Month / Day format
• Month
• Day
• Time zone - Note: If you set the time zone, for example, to + 01 and the weath-
er station is actuated using the DCF-signal, then the clock displays one hour
later than the DCF-signal.
• Language setting - To set the day on the display. The following codes can be
configured and selected using the "CH/+" and "-" buttons: EN (English), RU
(Russian), NL (Dutch), IT (Italian), ES (Spanish), DE (German), FR (French)
• RC - Enable or disable the DCF signal function.
• DST - Enable or disable automatic switching to daylight saving time.

7.2 Alarm setting

Setting the alarm
Press the "ALARM" button to access the alarm settings. The alarm time is now
displayed instead of the time. Press and then hold the "ALARM" button till the
corresponding alarm time starts flashing.
You can make the desired settings using the "CH/+" and " _ " buttons. Then press
the "ALARM" button again to save the alarm setting. The alarm is activated auto-
matically after setting the alarm time.
Turning the alarm on / off
Press the "ALARM" button in time mode. The alarm time is then shown on the
display. Press the "ALARM" button in alarm mode again, and an alarm icon is
displayed next to the time. This means that the alarm is turned on. Press the
"ALARM" button again to turn off the alarm. The icon disappears from the display.
22
English