WD Plus Bearware 303456/20191119HK016 Manual Del Usuario página 26

Outdoor temperature display:
The outdoor temperature is measured by the outdoor sensor and shown to an
accuracy of one tenth of a degree. The configured temperature unit is shown to
the right of the measured value. The temperature unit can be changed between
°C and °F. To do this, slide the °C / °F switch on the back of the weather station to
the desired position.
Channel display
The weather station receives the signal of the outdoor sensor automatically.
You can switch between the different channels using the "CH/+" button. Select
the same channel, which you select for the outdoor sensor. The channels of the
outdoor sensor can be selected on the device directly using a toggle switch.
Temperature alarm
With the temperature alarm, the base station shows a "
when the temperature falls below the 3°C mark in the outdoor display.
10. Additional settings
Min /max temperature and humidity
1. In normal time mode, press the "MAX / MIN" button again to display the
maximum measured outdoor temperature in the current channel.
2. Repeat the above steps to display the maximum and minimum measured
data record in the following order: maximum outdoor temperature -> mini-
mum outdoor temperature -> maximum outdoor humidity -> minimum out-
door humidity -> maximum indoor temperature -> minimum indoor temper-
ature -> maximum indoor humidity -> minimum indoor humidity
3. Press and hold the "MAX / MIN" button for about 3 seconds to clear the
MAX / MIN entries. MAX / MIN temperature or humidity readings (whether
indoor or outdoor) that are currently shown in the display, are cleared. Suc-
cessful clearing is confirmed by a "beep".
26
" icon in the display
English