GreenWorks GPW 1951 Manual Del Operador página 13

CONNECTING HIGH PRESSURE HOSE TO TRIGGER HANdLE
1. Align the pressure hose with the trigger handle and push up and into position.
2. With hose pushed into position on the trigger handle, secure in place by turning the hose lock clockwise
until fully tightened.
NOTE: For easier installation of the hose to the unit or trigger it is suggested to add pressure washer or
dish detergent to the rubber seal at each end of the hose. This will allow for easier installation and a snug
fit.
ASSEMBLING THE SPRAY WANd
■ Push the end of the spray wand into the trigger handle and rotate clockwise to secure.
■ Pull on the spray wand to be certain it is properly secured.
①
Fig. 5
(See Figure 6.)
ASSEMBLY
②
EN - 13
(See Figure 5.)
Fig. 6