GreenWorks GPW 1951 Manual Del Operador página 17

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

STARTING ANd STOPPING THE PRESSURE WASHER
C A U T I O N :
Do not run the pump without the water supply connected and turned on.
■ Connect the garden hose.
■ Turn the garden hose on then squeeze the trigger and run water hose with motor in OFF position until
a steady stream of water appears. This helps drain air from tank and lines.
NOTE: If the pressure washer pulsates and the water stream is intermittent turn the pressure washer off
and continue to bleed air out of the system. Ensure to check that the garden hose is fully turned on and
not kinked.
■ After ensuring the On/Off switch is in the OFF ( O ) position, connect the pressure washer to the power
supply.
■ Press the reset button on the pressure washer's plug to make sure the unit is ready for operation.
■ Rotate to ON ( I ) position on the switch to start the motor.
■ To stop the motor, release the trigger and rotate to OFF( O ) position on the switch.
NOTE: The pressure washer may be on and the system may have pressure even when the pump and/
or motor cannot be heard running. Always use caution around the pressure washer.
C A U T I O N :
Hold the trigger handle securely with both hands. Expect the trigger handle to move when the trigger
is pulled due to reaction forces. Failure to do so could cause loss of control and injury to yourself and
others.
NOTE: AUTO ON/OFF SWITCH: This pressure washer is equipped with an Auto Start/Stop feature. To
operate: Turn the power switch to the On (I) position. Pump will pressurize and shut down immediately.
Once the trigger of the gun is depressed the unit will turn on. Unit will shut off and be in standby mode
when trigger is released.
OPERATION
EN - 17
(See Figure 9.)
On(I) /Off(0) Switch
Fig. 9

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido